Spotlight on... Edexcel iGCSE Chemistry (4CH1)

Know your chemistry. Show it in your answers.

Welcome to our exam-board spotlight on Edexcel International GCSE Chemistry. Learning the content is one part of revision, but applying it, showing your working and explaining it clearly is another. Here's a short guide to making your next revision session count.

Spot the slip-ups

Getting a question wrong isn't a disaster. It's a clue to getting it right next time. Start by looking for the gap between what you know and what you actually wrote.

Check your mole ratios

Mole calculations often involve several steps, and getting the first part right doesn't guarantee the final answer will be correct.

Always start with a balanced equation when a calculation involves a reaction. Check the mole ratio before working out how much of a substance is needed. Don't assume the ratio is 1:1!

With all calculations, show your working, include the correct units where needed, and check that your final answer makes sense.

Key takeaway: balance the equation, check the mole ratio, show your working and include units where required.

Know your chemical tests

Remembering the name of a chemical test isn't enough. You also need to know what a positive result looks like.

For example, oxygen relights a glowing splint, while hydrogen produces a squeaky pop when tested with a lit splint. Mixing up the method or forgetting the result can cost you marks.

Revise the tests for gases, ions and other substances required by your specification, including the reagents used and the observations you should expect.

Key takeaway: learn the test, the method and the positive result together.

Explain energy changes

When explaining reactions, be careful not to confuse breaking bonds with making bonds.

Breaking chemical bonds requires energy (is endothermic), while making chemical bonds releases energy (is exothermic). The overall energy change in the reaction depends on the balance between these two processes.

For an exothermic reaction, more energy is released when bonds form than is absorbed when bonds break. For an endothermic reaction, the opposite is true.

Key takeaway: remember breaking bonds takes in energy; making bonds releases energy. Then apply this logic to the reaction in the question.

Make it count

After a practice question, don't stop at “that sounds right”. Compare your answer with the mark scheme. Identify what earned marks, what was missing, and what you'll change.

For calculations, check each step rather than looking only at the final answer. For written questions, look for missing scientific terms or explanations.

Then cover the mark scheme and try again. Learn the scientific meaning rather than treating one phrase as a password that always earns marks.

Think like a scientist

What if you're faced with an unfamiliar experiment on exam day? Start with three questions: what changes, what's measured, and what stays the same?

In a titration, for example, you need to use the correct apparatus, take measurements carefully, and add the solution slowly, drop by drop, near the end point. Swirling the flask helps the solutions mix thoroughly.

When suggesting an improvement to a method, be specific. Explain why your change helps rather than just writing “make it more accurate”. Repeating measurements, for example, can help identify anomalous results and calculate a mean.

Go to the source

Start with Pearson's official Chemistry qualification page. Match your specification, past papers and mark schemes to your qualification and assessment route. Use examiner reports alongside them, checking feedback in the context of the original question.

Try this revision loop: Answer → Check → Fix → Retry

Pick one question today. Find one thing to improve. Then have another go. One carefully corrected answer can be a better use of your time than racing through another paper without reviewing it.